ISL96017

• Integrated Digitally Controlled Potentiometer综合数字控制电位器
  • 128-Tap Positions 128抽头位置
  • 10kΩ, 50kΩ Total Resistance为10kΩ，总电阻为50kΩ
  • Monotonic Over Temperature单调过温
  • Non-Volatile Wiper Position Storage非易失性存储滑动端位置
  • 0 to VDD Terminal Voltage 0至VDD端电压
• I ² C Serial Interface I ^{2 C}串行接口
• 16kbit EEPROM 16kbit EEPROM中
  • 50 Years Retention @ < 55°C 50年保留@ <55℃
  • 100,000 Cycles Endurance循环寿命10万
• Single 3.3 ±0.3V supply单电源为0.3V ± 3.3
• 3mm x 3mm Thin DFN Package – 0.8mm Max Thickness, 0.65mm Pitch采用3mm x 3mm薄型DFN封装 - 最大厚度为0.8mm，0.65mm间距
• Pb-Free Plus Anneal Available (RoHS Compliant)无铅加退火有（符合RoHS）

This device integrates a 128-tap digitally controlled potentiometer, 16kbit of EEPROM, and a 2-wire serial interface.该器件集成了128抽头数字控制电位器，EEPROM的16kbit，和一个2线串行接口。 The device is powered by a single 3.3V supply.该装置是由一个单一的3.3V电源。 The potentiometer is available with total resistance of either 10kΩ or 50kΩ.电位计与任总电阻为10kΩ或50k的可用。

The memory is organized in 128 pages of 16 bytes each, to reduce total programming time.内存是组织128页，每页16字节，以降低总的编程时间。 All programming signals are generated on-chip.所有编程信号产生片上。

The potentiometer is implemented with a combination of CMOS switches and resistor elements.电位器是实施一个CMOS开关和电阻元件组合。 The position of the wiper can be stored in non-volatile memory and then be recalled upon a subsequent power-up.该抽头位置可存储在非易失性内存，然后被召回后，随后电。 The three terminals of the potentiometer are available for use as either a variable resistor or a resistor divider.电位器的三个码头可供无论是作为可变电阻或电阻分压器使用。